The purpose of this study was to synthesize TiO2-polymer composites able to act as photocatalyst membranes. TiO2 catalysts were prepared using the sol-gel method to contain 0.0, 0.5, 1.0, and 2.0 wt.% of embedded Ag particles, subsequently incorporated into natural rubber latex at a weight fraction of 15%. Samples of these ceramic powders were suspended in a latex emulsion (natural rubber), cast in Petri dishes and slowly dried in an oven. The resulting materials were evaluated by X-ray diffraction, scanning electron microscopy, energy-dispersive X-ray, diffuse reflectance spectroscopy, differential scanning calorimetry, thermogravimetry, and photocatalytic assaying using methylene blue as an organic pollutant reference. All composite membranes exhibited good photoactivity conferred by TiO2 powder, with 98% dye fading after 300 min of ultraviolet irradiation.

The appearance of resistant bacteria was found to reduce the efficiency of antimicrobial therapies with the current antibiotics, thereby increasing the need for more efficient drugs for the treatment of infections. Several studies have demonstrated an increase in antimicrobial activity following the interaction of several compounds with metal ions. The present study used a methodology adapted for antimicrobial bioassays using plant extracts, in compliance with the standards of the Clinical and Laboratory Standards Institute against Gram-positive and Gram-negative bacteria. The results obtained were considered appropriate for determining MIC, MBC as for performing antimicrobial sensitivity testing with good efficiency and reproducibility. The bacteriaPseudomonas fluorescens exhibited high sensitivity to the tested compounds, being efficient to evaluate the antibacterial activity. The bioassays with the metal complexes of flavonoid quercetin and Ga(III) ions, and synthetic ligand H2bbppd and Cu(II) ions showed a greater inhibitory effect than their individual ligands, thus, the addition indicated an increase in the antimicrobial activity after the coordination. Both metal complexes exhibit good antimicrobial performances, such as low minimum inhibitory concentration (MIC ≤ 250 µg/ml), bactericidal effect and a broad activity spectrum, which qualify these compounds as suitable candidates to the next step of drugs fabrication. Nevertheless, further studies on the mechanism of growth inhibition and toxicity are needed, in order to evaluate the potential of therapeutic application.

Pechini method has been used to synthesize MN powders with stoichiometric control. By this method, K and Li-doped MN in the range from 0.1 to 5.0 mol% of dopants have been obtained at relatively lower temperatures than it is possible with the conventional mixture of oxides. The results from BET analysis indicated that the doped powders have lower surface area and the attrition milling promotes an increase in surface area values for all powders. Rietveld method was used to calculate the mean crystallite size and the microstrain in the crystal. With additions of up to 5.0 mol% of K or 2.0 mol% of Li, it is possible to obtain MN as a solid solution. Both dopants change the cell parameters of the columbite phase crystal, reduce the microstrain, and increase the main crystallite size. The analysis of results from SEM indicates that powders prepared with addition of dopants are more agglomerate than pure PMN powder.